Vulcan-Hart GCO2D Especificações descarregar pdf (Página 17)

— 17 —

Cooking

1. Open doors and load the product into the oven. Place pans in the center of the racks. Close doors.

2. Set ROAST temperature and time. Set HOLD temperature and GENTLE BAKE time, if desired. GENTLE

BAKE time may not be more than ROAST time. GENTLE BAKE will cycle the fan during the set time at the

beginning of the cooking cycle.

3. Press the START/STOP button to start the cooking cycle.

4. At the end of the cooking cycle, the buzzer will sound continuously if the HOLD mode is OFF. If the HOLD

mode is ON, there will be a short beep at the beginning of Second Stage Cooking (oven temperature will

begin to decline to the HOLD temperature), and a long beep (20 seconds) at the end of the cooking cycle.

(See ROAST AND HOLD OPERATION.)

5. When product is done, open doors and carefully remove cooked product from the oven. Wipe up any spills.

End of Day

1. Push ON/OFF/OVEN COOL switch to OVEN COOL. Leave door ajar while the fan is on to cool the oven.

2. When the oven has cooled sufficiently, push the ON/OFF/OVEN COOL switch to the OFF position and clean

the oven.

ERROR MESSAGES — GCO2C OVEN

E-01 High limit error. Contact your local Vulcan authorized service representative.

E-02 Low limit error. Contact your local Vulcan authorized service representative.

E-03 High ambient temperature (215°F/101.7°C). Contact your local Vulcan authorized service representative.

E-04 Low ambient temperature (32°F/0°C). Let control warm up after cold storage.

E-05 Ignition failure. After trying ignition three times, contact your local Vulcan authorized service representative.

E-06 Thermocouple probe open. Contact your local Vulcan authorized service representative.

When calling for service, please advise what error code was displayed.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 23 24

Sem comentários

Vulcan-Hart GCO2D Especificações Página 17